More A Heat analysis shall be used to determine the percentage of carbon, manganese, phosphorus, sulfur, vanadium, titanium, nickel, chromium, molybdenum, columbium, and copper for the required chemical composition. Tension test shall be used to evaluate the required tensile properties such as tensile strength, yield strength and elongation. This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
|Published (Last):||1 September 2017|
|PDF File Size:||5.32 Mb|
|ePub File Size:||20.62 Mb|
|Price:||Free* [*Free Regsitration Required]|
A number in parentheses indicates the year of last reapproval. Such requirements apply only when specified in thepurchase order. Within the text, theSI units are shown in brackets. The values stated in eachsystem may not be exact equivalents; therefore, each systemshall be used independently of the other. Combining valuesfrom the two systems may result in non-conformance with thestandard.
Referenced Documents2. General Requirements For Delivery3. Materials and Manufacture4. The nitrogen content need not bereported, regardless of which steelmaking practice was used. Chemical Composition5. Where the amount of tin is less than 0.
Those that are considered suitable for use with this specifica-tion are listed by title:S1. Vacuum TreatmentS2. Product AnalysisS5. Ultrasonic ExaminationS Single Heat BundlesS Maximum Tensile StrengthS ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentionedin this standard.
Users of this standard are expressly advised that determination of the validity of any such patent rights, and the riskof infringement of such rights, are entirely their own responsibility. This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years andif not revised, either reapproved or withdrawn.
Your comments are invited either for revision of this standard or for additional standardsand should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of theresponsible technical committee, which you may attend.
If you feel that your comments have not received a fair hearing you shouldmake your views known to the ASTM Committee on Standards, at the address shown below. BThe sum of columbium and vanadium shall not exceed 0. BA maximum ratio of 0.